Log entry time 16:33:03 on October 13, 2006

Entry number 124262

SL: Mark Jones
Target: John Schaub
RC: Betsy Beise

• Production 8-9am
  
• Do BPM and BCM calibration from 12:08
• REsume production at 15:17
  

• 08:00 continuation of run 31436
• At 9:03 call MCC to put HW plate IN.
• At around 9:07 MCC starts to investigate Hall B  problems. Could  lead to beam interupts to Hall C.
• Ran flipper program. Had to run it twice to update the PC Pos setting.
• 09:08 Run 31437 started , but last 70 minutes of run have no beam.
• 12:08 beam back. Will do BCM and BPM calibration
• 12:20 run 31438 started. Beam problems. Junk run.
  
• 12:58 Run 31439 started. Beam problems at beginning of run. MCC found a PID loop was still on and fixed it at about 15 minutes into run.
  
• 15:17 Run 31440 started. Production.
  
• 15:33 Beam down to reLEM the north linac
• 15:45 Run 31441 started.
  

• Run 31436: Production run at 60uA; PS=1000; HWP is OUT (329K)
• Run 31437: Production run at 60uA; PS=1000; HWP is IN (135K)
• Run 31438: BPM and BCM calibration PS=1000; HWP is IN junk
  
• Run 31439: BPM and BCM calibration, PS=1000; HWP is IN. Both Hall A & B in controlled access during the run.
• Run 31440: Production run at 60uA; PS=1000; HWP is IN (74K)
• Run 31441: Production run at 60uA; PS=1000; HWP is IN