E-Detector Motion System

Motion Mechanism GUI

• login to cdaql* as cvxwrks
• cd MEDM/compton
• edm -x HLC_E_CompED.edl

General Description

• The electron detector is connected to the QWAD using the custom made [Flex-cable]. The detector is placed inside the vacuum-can whereas the QWAD boards are connected from outside the vacuum-can using appropriate flanges used between the Flex-cable and the QWAD. The connection between e-detector and the QWAD (if the vacuum - can was transparent) can be depicted as in the attached picture.

• The electron detector vacuum - can has a motion mechanism to allow us to move the detector vertically in and out of the beam along with the ability to rotate the detector facing the beam. A schematic view of the assembly can be seen here.

• We are using a stepping motor identified as KML062S04 for vertical motion ( data sheet ) of detector using a MDC accuator ( specifications ). This motor is being controlled by a single axis IDC Controller (User Manual). The Motion Controller can be controlled through its keypad or via computer terminal after installing its software provided on their website

• Motion Controller:
  • Vertically downward motion of the actuator is referred to as 'positive' direction based on the current settings of the controller.
  • All numbers displayed on the controller uses appropriate units of inch and second
  • The Actuator has 3 physically verifiable positions which correspond to a switch on the actuator.
    • EOT+ (end of travel switch in positive direction) will not be used
    • EOT- (end of travel switch in negative direction) used as Garage
    • Home
  • Current Controller Settings:

1. Current: 1.5A
2. Resolution: 18000
3. Inductance: 16 mH
4. Direction: positive
5. Distance Unit: cm
6. Velocity: cm/s
7. Acceleration Unit: cm/s^2
8. Gear Ratio: (GR) = 10:1

Operation

At EOT- (physically top most) the actuator position read back (as seen on the controller display) is

 -3.7833
 00000000      00000000

AC.02 VE.1 DA2 GO

 +2.0000
 00000000      00000000

AC.02 VE.1 DA1 GO

 +1.0000
 00000000      00000000

AC.02 VE.1 DA-2 GO

 -2.0000
 00000000      00000000

AC.02 VE.1 DI1 GO

 -1.0000
 00000000      00000000

Controller Settings

We shall maintain two files for the controller settings

• The most recent settings updated on Nov 29, 2010
• The last working settings updated on Oct 14, 2010

The list of programs loaded in the current configuration are

1. Prog 1: Go Home;
2. Prog 2: 2 cm above chicane beam;
3. Prog 3: Garage, EOT-;
4. Prog 4: 5 mm above chicane beam
5. Prog 10: Incremental motion : -2 mm
6. Prog 11: Incremental motion : -1 mm
7. Prog 12: Incremental motion : +1 mm
8. Prog 13: Incremental motion : +2 mm
9. Prog 14: Incremental motion : -0.5 mm
10. Prog 15: Incremental motion : +0.5 mm
11. Prog 16: Incremental motion : -0.2 mm
12. Prog 17: Incremental motion : +0.2 mm
13. Prog 98: Motor Stopper