Moller Polarimeter

General information

This article will cover all things Hall-C Moller. Currently, this includes all of the Qweak information. Information for past experiments can be found in the experiments section. This page is currently under construction, so please come back soon for more, or update me.

Documentation and references

The following are useful references:

• A High Precision Polarimeter (jlab document JLAB-PHY-99-29)
• Loppacher's thesis
• g0 polarization (draft 3)

The following is a plot showing a good tune of the apparatus. It was taken Jan 30, 2011 from run 700, with conditions: hallc:p is 1159 MeV, with a 1um target.

As of Jan 30, 2011 the following quad current and collimator positions are as follows:

Quad 1: 93 A
Quad 3: 129 A
Col #		Position (cm)
1		-1.55
2		-1.55
3		-4.05
4		-4.15
5		Out of beam
6		-3.20
7		-3.20

Hardware configuration & changes

NB: Up until last run in December (date tbd)we used BCM 2 with gain from Kat's Faraday cup measurements.

• (Jan 30, 2011) Increased the left and right detector high voltages, as seen below. This is a significant change in the voltages since tune-up, and is evidence of pmt radiation effects.

	New HV	Old HV
Left	1630	1480
Right	1655	1520

• We've been having trouble with large charge asymmetries after switching the IHWP. To fix this, we've been slightly altering the Pockel cell HV. Apparently the wiki didn't save the numbers when I put them in earlier, so I'll put the ones I don't have with me in tomorrow.

IHWP	IN	OUT
POS	43880	---
NEG	40291	----

Experiments

• Sane Experiment
  • Sane Moller How-to

• Qweak
  • Qweak Moller How-To (pdf)
  • Qweak Moller How-To (tex file)