Difference between revisions of "Hcreboot6"
From HallCWiki
Jump to navigationJump to search (Created page with "Connect to this link: https://hcreboot6.jlab.org/ (User 'hccuser') * Port 1: portservhc26 -- portserver controlled by iochc26 * Port 2: VXM-1 Target motor controller * Port...") |
|||
| (6 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
Connect to this link: https://hcreboot6.jlab.org/ (User 'hccuser') | Connect to this link: https://hcreboot6.jlab.org/ (User 'hccuser') | ||
| + | |||
| + | Located in PolHe3 Rack on the floor under the pivot | ||
* Port 1: portservhc26 -- portserver controlled by iochc26 | * Port 1: portservhc26 -- portserver controlled by iochc26 | ||
* Port 2: VXM-1 Target motor controller | * Port 2: VXM-1 Target motor controller | ||
| − | * Port 3: | + | * Port 3: Acromags for fiber end RTDs |
| − | * Port 4: | + | * Port 4: N2 mass flow meters (?) |
| − | * Port 5: | + | * Port 5: polhemaxnet2 (long. left and right 2) |
| − | * Port 6: | + | * Port 6: Oven Controls |
| − | * Port 7: | + | * Port 7: hccam-gaspanel camera |
* Port 8: hctsv10 -- portserver used for fiber end RTDs | * Port 8: hctsv10 -- portserver used for fiber end RTDs | ||
Latest revision as of 10:00, 22 March 2020
Connect to this link: https://hcreboot6.jlab.org/ (User 'hccuser')
Located in PolHe3 Rack on the floor under the pivot
- Port 1: portservhc26 -- portserver controlled by iochc26
- Port 2: VXM-1 Target motor controller
- Port 3: Acromags for fiber end RTDs
- Port 4: N2 mass flow meters (?)
- Port 5: polhemaxnet2 (long. left and right 2)
- Port 6: Oven Controls
- Port 7: hccam-gaspanel camera
- Port 8: hctsv10 -- portserver used for fiber end RTDs
