Difference between revisions of "Pol He-3 Target Motion Reset"
From HallCWiki
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
To reset the hall C target motion, several devices need to be rebooted. | To reset the hall C target motion, several devices need to be rebooted. | ||
| − | '''WARNING: | + | '''WARNING: You must call MCC and mask the target before doing this procedure''' |
| − | First, use hcreboot5 to turn off the iochc26 VME crate (outlet 2). | + | # First, use [[hcreboot5]] to '''turn off''' the iochc26 VME crate and '''leave it off for now''' (outlet 2). |
| − | + | # Next, use [[hcreboot6]] to reboot | |
| − | Next, use hcreboot6 to reboot portservhc26 (outlet 1) and the VXM-1 Motor controller (outlet 2). Wait | + | ## portservhc26 (outlet 1) and |
| − | + | ## the VXM-1 Motor controller (outlet 2). | |
| − | Finally, use hcreboot5 to turn iochc26 (outlet 2 again) back on. The IOC will take a few minutes to boot up completely. | + | ## Wait 60 seconds for the portserver to boot up. |
| + | # Finally, use [[hcreboot5]] to turn iochc26 (outlet 2 again) back on. The IOC will take a few minutes to boot up completely. When it does, the white fields in the alarm handler and Target motion control GUI will go back to their regular colors. | ||
| + | # Click the 'Initialize' button at the top of the Target Motion Control GUI and wait for the process to complete. | ||
| + | # Move to your chosen target position and '''verify that the 'Encoder Readout (volts)' field matches the setting you expect listed next to the vertical target position bar!''' | ||
Latest revision as of 09:15, 8 August 2020
To reset the hall C target motion, several devices need to be rebooted.
WARNING: You must call MCC and mask the target before doing this procedure
- First, use hcreboot5 to turn off the iochc26 VME crate and leave it off for now (outlet 2).
- Next, use hcreboot6 to reboot
- portservhc26 (outlet 1) and
- the VXM-1 Motor controller (outlet 2).
- Wait 60 seconds for the portserver to boot up.
- Finally, use hcreboot5 to turn iochc26 (outlet 2 again) back on. The IOC will take a few minutes to boot up completely. When it does, the white fields in the alarm handler and Target motion control GUI will go back to their regular colors.
- Click the 'Initialize' button at the top of the Target Motion Control GUI and wait for the process to complete.
- Move to your chosen target position and verify that the 'Encoder Readout (volts)' field matches the setting you expect listed next to the vertical target position bar!
