Difference between revisions of "Hall C Weekly Meeting - March 4, 2013"
From HallCWiki
(New page: Minutes Hall C Meeting 3/4/2013 *Walter Kellner **The SOS base frame was removed from the Hall. **Last bit of SOS rail was removed **The C-can and platform have been dismounted **The Hall...) |
(Add Paul Brindza's notes) |
||
| Line 19: | Line 19: | ||
*Paul Brindza | *Paul Brindza | ||
| + | **Design work in progress | ||
| + | ***Noble Gas Cerenkov (NGC) done waiting for UVA comments | ||
| + | ***Dipole Vacuum spool | ||
| + | ***Sieve slit and vacuum spools between HB-Q1 | ||
| + | ***Moller Quad Coil Spec and Compton | ||
| + | ***HMS Data Cable Duct replacement design | ||
| + | ***Shield House door opener – motor, transmission, chain drive-mechanical design | ||
| + | **SHMS | ||
| + | ***Q1 magnet yoke stacking started at SMI- JLAB visit | ||
| + | ***HB magnet helium vessel parts machining and bending | ||
| + | ***SHMS DC Power Supplies done ready for Factor Acceptance Test | ||
| + | ***Dipole- Preparations for 10 turn 1 meter trial coil | ||
| + | ***Bid of steel structure canceled- no qualified small businesses | ||
*Bert Manzlak | *Bert Manzlak | ||
**Reminds people to check with Walter or Andy before coming into hall | **Reminds people to check with Walter or Andy before coming into hall | ||
Latest revision as of 16:29, 11 March 2013
Minutes Hall C Meeting 3/4/2013
- Walter Kellner
- The SOS base frame was removed from the Hall.
- Last bit of SOS rail was removed
- The C-can and platform have been dismounted
- The Hall C crane is still down for repairs. Expected to be back in service this week. In the mean time a crane is being rented from Lockwood
- The groundwater leak in the truck ramp has finally been fixed
- There is still a bad leak near the labyrinth door
- Mike Fowler
- The SHMS rail installation is complete
- The SHMS structure assembly is being sent out for rebidding. This will delay the SHMS structure assembly by a month.
- Joe Beaufait (via email)
- Spoke to engineering group for help with rerouting of G0 patch panel
- G0 water cooled leads found. Are in good enough condition to reuse.
- Clean power water issue reported as resolved by facilities, but Joe has not been able to get a report on what was actually done.
- Paul Brindza
- Design work in progress
- Noble Gas Cerenkov (NGC) done waiting for UVA comments
- Dipole Vacuum spool
- Sieve slit and vacuum spools between HB-Q1
- Moller Quad Coil Spec and Compton
- HMS Data Cable Duct replacement design
- Shield House door opener – motor, transmission, chain drive-mechanical design
- SHMS
- Q1 magnet yoke stacking started at SMI- JLAB visit
- HB magnet helium vessel parts machining and bending
- SHMS DC Power Supplies done ready for Factor Acceptance Test
- Dipole- Preparations for 10 turn 1 meter trial coil
- Bid of steel structure canceled- no qualified small businesses
- Design work in progress
- Bert Manzlak
- Reminds people to check with Walter or Andy before coming into hall
