Difference between revisions of "Pol He-3 Target Motion Reset"
From HallCWiki
Jump to navigationJump to search (Created page with "To reset the hall C target motion, several devices need to be rebooted. '''WARNING: After iochc26 boots up, the target will home itself, so you need to mask the FSD first!!''...") |
|||
| Line 4: | Line 4: | ||
First, use hcreboot5 to turn off the iochc26 VME crate (outlet 2). | First, use hcreboot5 to turn off the iochc26 VME crate (outlet 2). | ||
| + | |||
Next, use hcreboot6 to reboot portservhc26 (outlet 1) and the VXM-1 Motor controller (outlet 2) | Next, use hcreboot6 to reboot portservhc26 (outlet 1) and the VXM-1 Motor controller (outlet 2) | ||
| + | |||
Finally, use hcreboot5 to turn iochc26 (outlet 2 again) back on. | Finally, use hcreboot5 to turn iochc26 (outlet 2 again) back on. | ||
After iochc26 boots up, the target will home itself, so befor | After iochc26 boots up, the target will home itself, so befor | ||
Revision as of 15:41, 4 December 2019
To reset the hall C target motion, several devices need to be rebooted.
WARNING: After iochc26 boots up, the target will home itself, so you need to mask the FSD first!!
First, use hcreboot5 to turn off the iochc26 VME crate (outlet 2).
Next, use hcreboot6 to reboot portservhc26 (outlet 1) and the VXM-1 Motor controller (outlet 2)
Finally, use hcreboot5 to turn iochc26 (outlet 2 again) back on.
After iochc26 boots up, the target will home itself, so befor
