Difference between revisions of "Pol He-3 Target Motion Reset"
From HallCWiki
Jump to navigationJump to search| Line 3: | Line 3: | ||
'''WARNING: After iochc26 boots up, the target will home itself, so you need to mask the FSD first!!''' | '''WARNING: After iochc26 boots up, the target will home itself, so you need to mask the FSD first!!''' | ||
| − | First, use hcreboot5 to turn off the iochc26 VME crate (outlet 2). | + | # First, use hcreboot5 to '''turn off''' the iochc26 VME crate and '''leave it off for now''' (outlet 2). |
| − | + | # Next, use hcreboot6 to reboot | |
| − | Next, use hcreboot6 to reboot portservhc26 (outlet 1) and the VXM-1 Motor controller (outlet 2). Wait a couple minutes for the portserver to boot up. | + | ## portservhc26 (outlet 1) and |
| − | + | ## the VXM-1 Motor controller (outlet 2). | |
| − | Finally, use hcreboot5 to turn iochc26 (outlet 2 again) back on. The IOC will take a few minutes to boot up completely. | + | ## Wait a couple minutes for the portserver to boot up. |
| + | # Finally, use hcreboot5 to turn iochc26 (outlet 2 again) back on. The IOC will take a few minutes to boot up completely. | ||
Revision as of 18:17, 6 December 2019
To reset the hall C target motion, several devices need to be rebooted.
WARNING: After iochc26 boots up, the target will home itself, so you need to mask the FSD first!!
- First, use hcreboot5 to turn off the iochc26 VME crate and leave it off for now (outlet 2).
- Next, use hcreboot6 to reboot
- portservhc26 (outlet 1) and
- the VXM-1 Motor controller (outlet 2).
- Wait a couple minutes for the portserver to boot up.
- Finally, use hcreboot5 to turn iochc26 (outlet 2 again) back on. The IOC will take a few minutes to boot up completely.
