Difference between revisions of "Run Plan for Kaon LT Luminosity Scan"
From HallCWiki
Jump to navigationJump to search (→Goal) |
|||
| Line 7: | Line 7: | ||
* C (''z''=1.5% RL) - maximum current 65uA | * C (''z''=1.5% RL) - maximum current 65uA | ||
* Al dummy - maximum current 40uA | * Al dummy - maximum current 40uA | ||
| − | |||
| − | |||
== Initial Setup == | == Initial Setup == | ||
# '''Set PS1 and PS3 DAQ rates to 1.5kHz''', to give a total rate to disk of about 3kHz. | # '''Set PS1 and PS3 DAQ rates to 1.5kHz''', to give a total rate to disk of about 3kHz. | ||
Revision as of 23:05, 14 October 2018
Luminosity scans on LH2 and z=1.5% RL C targets.
Goal
The electrons in the HMS will be used to monitor cryotarget boiling, while the positive polarity SHMS will be used to investigate the reliability of hadron tracking efficiencies at high rates. We will use three different targets:
- standard 10cm LH2
- C (z=1.5% RL) - maximum current 65uA
- Al dummy - maximum current 40uA
Initial Setup
- Set PS1 and PS3 DAQ rates to 1.5kHz, to give a total rate to disk of about 3kHz.
