Elong-14-04-15

From HallCWiki
Revision as of 11:24, 15 April 2014 by Ellie (talk | contribs) (→‎Results)
Jump to navigationJump to search

Pzz=15% with ND3 Scenario

In a worst case scenario where we are stuck with Pzz=15% on an ND3 target, I looked into what single kinematics point we could spend all of our time on that would give us the best measurement. (Note: For each of these plots, the systematics were hard-wired to the specific kinematics we had listed for the proposal. Don't trust the systematics. The statistics are what's important.)

Individual frames for each of the plots below can be found here.

First I did a Q^2 scan of the SHMS

2014-04-15-shms-q2-scan.gif

This was followed by an x scan of the HMS

2014-04-15-hms-x-scan.gif

and an x scan of the SHMS.

2014-04-15-shms-x-scan.gif

After each of these, it looked like our best point was to put the central SHMS at x=0.28 and Q^2=1.47 with the HMS at x=0.41 and Q^2=3.33. If we do that, and are ok lowering our W^2, we can increase the statistics in the x=0.4 point by opening up the cut

2014-04-15-w2-cut-scan.gif

Results

For the plots below, I fixed the systematic uncertainty by assuming that we'll have the same number of cycles for both spectrometers over the full length of time (36 cycles). I also included Gerry Miller's recent 6q-hidden color plots. If we don't lower the W cut and leave it at W>1.85 GeV, we get

2014-04-15-bestcase-w-185.png

and if we can lower the W cut to W>1.5, we get

2014-04-15-bestcase-w-150.png