Hall C CODA/DAQ Layout
Hall C CODA Layout
- Detailed 'User' instructions are on the Hall_C_DAQ page. That includes the ROC layout, standard recovery procedures, etc. Read and understand that first.
CODA process and file locations
There are two primary hosts dedicated to running the SHMS and HMS DAQs:
- HMS: coda@cdaql5
- SHMS: coda@cdaql6
When running in 'coincidence' mode, all ROCs (SHMS+HMS) are picked up by the 'SHMS' configuration running under coda@cdaql6
There is nothing 'special' about those machines however. If needed, failover to another host by replacing 'cdaql6' with a new/different host in
They share a common NFS mounted 'coda' directory and
The 'data mover' algorithm takes care of copying CODA data files from the Hall C system(s) to tape.
The initial copy is done using 'coda:coda/scripts/copy_file_to_tape.sh', triggered when each CODA run is stopped. It initiates a 'jput' from the system that has the data drive mounted to minimize unnecessary network traffic. See the script for details.
Clean-up of the local files is managed by the 'jmirror' tool through the following cron entry and associated script running under coda@cdaql1 (again, this should run on the system with the data file system physically attached to avoid unneeded network traffic).
## 'jmirror' verifies (via crc/md5sum) that all files in the raw.copiedtotape/ directory ## are in fact on tape. (If they are not, it will copy them now). Once they are ## verified to be on tape, it will remove them from the Hall C file system. ## ## Leave files on local disk for a nominal 48 hours before removing. ## Files will only be removed from local disk if both the original and 'dup' ## copies have been written and verified to be on tape. @daily /$HOME/bin/jmirror-sync-raw.copiedtotape 2>&1 | egrep -v 'Found 0 files, comprising 0 bytes.|^WARN Ignoring zero-length file:|already exists|^WARN Unable to load previously calculated MD5' ## Sanity check of file count in ~/data/raw ## (Should be small unless there's an issue with CODA crashing before end of run, or file transport to tape) ## - Should probably convert this crontab entry to munin plugin at some point @daily if [ `ls /$HOME/data/raw/ | wc -l` -gt 6 ]; then ( date; echo "$USER@$HOST"; echo "Warning: Extra files in $HOME/data/raw. Verify things are working and manually move (non-active!) files to ../raw.copiedtotape. A cronjob will ensure they are pushed to tape later." ); fi; ## clean up $HOME/debug_logs/ @daily /usr/sbin/tmpwatch -qs --ctime 7d /$HOME/debug_logs/
All of the CODA configurations, coda:bin/, and other directories are maintained with git.
The remote repos are stored on the 'hallcgit.jlab.org' server.