RC Meeting, Tuesday, Dec 7, 2021

RC Meeting Information

  No RC meeting Tuesday
   Have RC meeting on Wed.

RC Daily Meetings are at 10 AM, remote

• Bluejeans remote connection information:

 To join the Meeting:
 https://bluejeans.com/861439920
 To join via Room System:
 Video Conferencing System: bjn.vc -or-199.48.152.152
 Meeting ID : 861439920
 To join via phone :
 1)  Dial:
   +1.408.740.7256 (US (San Jose))
   +1.888.240.2560 (US Toll Free))
   +1.408.317.9253 (US (Primary, San Jose))
   (see all numbers - http://bluejeans.com/numbers)
 2)  Enter Conference ID : 861439920

Useful Links

• Fall 2021 Shift Schedule
• Hall-C Controls
• Hall-C Logbook
• MCC White Board

Current Status

• Summary of data and plans forward
• Running production on LD2 Q2=3.85, W=3.07, x=0.31, low epsilon, HMS angle=35.12 deg, HMS momentum = -1.332 GeV/c, SHMS angle= 6.39deg, SHMS momentum=-6.538 GeV/c;
• 6uA was the best current for running at this angle.
• Rate estimeta and plans . RUn this setting until Saturday morning.
• Yesterday's Day , Swing and Owl shift went smoothly. Current number of pions 2263

Current Run Plan

• Day :
  • LD2 Q2=3.85, W=3.07, x=0.31, low epsilon, HMS angle=35.12 deg, HMS momentum = -1.332 GeV/c, SHMS angle= 6.39deg, SHMS momentum=-6.538 GeV/c;
  • Need daily one hour trigger 3/4 runs.
  • BCm calibration at 2:30
• Swing
  • LD2 Q2=3.85, W=3.07, x=0.31, low epsilon, HMS angle=35.12 deg, HMS momentum = -1.332 GeV/c, SHMS angle= 6.39deg, SHMS momentum=-6.538 GeV/c;
• Owl
  • LD2 Q2=3.85, W=3.07, x=0.31, low epsilon, HMS angle=35.12 deg, HMS momentum = -1.332 GeV/c, SHMS angle= 6.39deg, SHMS momentum=-6.538 GeV/c;
• FADCmode 10 run 13695 taken on Saturday.
• Take the 2.5 hours Al dummy at end of running on Saturday morning.

Notices in Effect for Shift Crew

• The Raster Coil pair Ax and Ay are off. Raster needs to be at 4x4.
• With LHe alarms it is good to check the cameras for plumes. If no plume and it is below the LO alarm and above LOLO then monitor with a plot and halog the problem.
• With LNitrogen alarms are not that critical. Just need to start monitoring the problem with plot and halog.

Current Issues

• The Raster Coil pair Ax and Ay are off
• Elevator is not working
• Noticed bug in Prescale GUI

Planned Accesses to the Hall

• none

Planned Accelerator Configuration Changes

• none

Special Requests

• none