RC Meeting and Run Plan, Wednesday, January 7th 2020
From HallCWiki
Jump to navigationJump to searchRC Meeting Information
RC Daily Meetings are at 4:15 PM, 2nd floor Counting House Meeting Room
- Bluejeans remote connection information:
To join the Meeting: https://bluejeans.com/861439920 To join via Room System: Video Conferencing System: bjn.vc -or-199.48.152.152 Meeting ID : 861439920 To join via phone : 1) Dial: +1.408.740.7256 (US (San Jose)) +1.888.240.2560 (US Toll Free)) +1.408.317.9253 (US (Primary, San Jose)) (see all numbers - http://bluejeans.com/numbers) 2) Enter Conference ID : 861439920
Useful Links
Target Readiness
- Raytum people finished laser fiber repairs. (EPR fiber bundle?)
Remaining work:
- 1 BNC cables need to be made and attached to these coils.
Current Run Plan
- Currently measuring laser polarization with new polarimeter
- Friday (?): Optimistically, Close up the enclosure. Start taking 1-pass data for two days with the same settings as in December.
Notices in Effect for Shift Crew
- Policy for CANS-related hall status change: Make a logbook entry when the hall goes in, or comes out of laser-controlled access.
- Magnet policies
- HMS Q1 must be ramped down in 50A steps in all cases
- Do not ramp HMS Q2 to zero, only go to 10A and then switch off power.
- Inform the RC of any access that the Target Team requires. The RC will coordinate with RadCon to make everything run smoothly.
- The operators have been somewhat careful with our beam orbit locks. Please make sure that the orbit locks are enabled and the beam does not drift from its nominal position.
- Ramp rate lock instructions are here and added to checklist[1]
- Temporary Laser instructions can be found here [2]
Current Issues
- Polarimetry debugging in progress
- (ARUN) Transverse didn't indicate a higher polarization. Need to understand why?
Ongoing Work in the Hall
- DC Power (Mark Todd) needs an escorted access tomorrow at 9am (~1 hour)
Planned Accelerator Configuration Changes
Special Requests
- Keep target expert schedule filled out on whiteboard