Difference between revisions of "Signal Flow Layout"
| (One intermediate revision by the same user not shown) | |||
| Line 16: | Line 16: | ||
---- | ---- | ||
| − | |||
The entire signal flow from the electron detector the the v1495 can be seen in the [[Media: EDet_QWAD_v1495_cablelayout.pdf |current cable layout]] | The entire signal flow from the electron detector the the v1495 can be seen in the [[Media: EDet_QWAD_v1495_cablelayout.pdf |current cable layout]] | ||
Latest revision as of 23:48, 10 October 2010
The signals from the top cluster of 32 strips (0-31) are given as an input (via QWAD) to the v1495 board (say) Slave-1 (s1). In the slave boards:
the A port gets signals from plane-1 the B port gets signals from plane-2 the D port gets signals from plane-3 the E port gets signals from plane-4
The signals from the middle cluster of 32 strips (32-63) reach the v1495 board (say) Slave-2 (s2).
The signals from the bottom cluster of 32 strips (64-95) reach the v1495 board (say) Slave-3 (s3).
Each slave-board delivers its trigger information to the master-board through its C-port. In the current method of implementation, the pin-assignment is: C(0) : the 'Good Trigger' information based on the 32 strip information of the current patch of signals from detector-board. C(1-4): the hit map of the top 4 strips in this patch of 32 strips C(5-8): the hit map of the bottom 4 strips in this patch of 32 strips.
The entire signal flow from the electron detector the the v1495 can be seen in the current cable layout
