Difference between revisions of "Pol He-3 Rotation Stages"
From HallCWiki
(→Rotation Stage Control) |
(→Power to camera and lamp in Optics Box =) |
||
Line 9: | Line 9: | ||
[[File:Rotation_stage_control.png|thumb|300px|Rotation Stage Controls]] | [[File:Rotation_stage_control.png|thumb|300px|Rotation Stage Controls]] | ||
− | == Power to camera and lamp in Optics Box | + | == Power to camera and lamp in Optics Box == |
* Use Outlet 8 on [[Hcreboot7]] | * Use Outlet 8 on [[Hcreboot7]] | ||
Note that the camera must be ON | Note that the camera must be ON |
Revision as of 20:09, 17 February 2020
Contents
Pol He-3 Rotation Stages
The camera snapshots are to roughly verify that the rotation stages are where we think they are. This is done by looking at the relative location of the marks outlined in red. One mark is on the rotating portion, the second on a fixed part of the rotation stage.
Rotation Stage Control
- Bring up the rotation stage controls:
go_polhe3_rotation-stage
Power to camera and lamp in Optics Box
- Use Outlet 8 on Hcreboot7
Note that the camera must be ON
Note that the camera is sensitive to the laser light as well. Try turning off all but one laser and adjusting the power until you can clearly see the marks noted on the images in the snapshots.
Snapshots
Feb 17 2020 snapshots before fine tuning
- These snapshots were taken after the rotation stages were installed in the longitudinal laser path and re-aligned in the Hall
- Rotation stage angles:
- Upper-left: Longitundinal left 2 : 325.5
- Bottom-left: longitudinal left : 263.0
- Upper-right: longitudinal right 2 : 8.80
- Bottom-right: longitudinal right : 0.00