Difference between revisions of "RC Meeting and Run Plan, Friday, December 13th 2019"
From HallCWiki
(→Notices in Effect for Shift Crew) |
(→Notices in Effect for Shift Crew) |
||
Line 37: | Line 37: | ||
** HMS Q1 must be ramped down in 50A steps in all cases | ** HMS Q1 must be ramped down in 50A steps in all cases | ||
** Do not ramp HMS Q2 to zero, only go to 10A and then switch off power. | ** Do not ramp HMS Q2 to zero, only go to 10A and then switch off power. | ||
− | * There | + | ** There IS a lock available for the ramp rate. I will post instructions on how to check if it was on. |
* Inform the RC of any access that the Target Team requires. The RC will coordinate with RadCon to make everything run smoothly. | * Inform the RC of any access that the Target Team requires. The RC will coordinate with RadCon to make everything run smoothly. | ||
* The operators have been somewhat careful with our beam orbit locks. Please make sure that the orbit locks are enabled and the beam does not drift from its nominal position. | * The operators have been somewhat careful with our beam orbit locks. Please make sure that the orbit locks are enabled and the beam does not drift from its nominal position. |
Revision as of 17:07, 13 December 2019
Contents
RC Meeting Information
RC Daily Meetings are at 4:15 PM, 2nd floor Counting House Meeting Room
- Bluejeans remote connection information:
To join the Meeting: https://bluejeans.com/861439920 To join via Room System: Video Conferencing System: bjn.vc -or-199.48.152.152 Meeting ID : 861439920 To join via phone : 1) Dial: +1.408.740.7256 (US (San Jose)) +1.888.240.2560 (US Toll Free)) +1.408.317.9253 (US (Primary, San Jose)) (see all numbers - http://bluejeans.com/numbers) 2) Enter Conference ID : 861439920
Useful Links
Current Status
- Priority: Target Work
- Heading into controlled access to open the target enclosure
Current Run Plan
Notices in Effect for Shift Crew
- Policy for CANS-related hall status change: Make a logbook entry when the hall goes in, or comes out of laser-controlled access.
- Magnet policies
- HMS Q1 must be ramped down in 50A steps in all cases
- Do not ramp HMS Q2 to zero, only go to 10A and then switch off power.
- There IS a lock available for the ramp rate. I will post instructions on how to check if it was on.
- Inform the RC of any access that the Target Team requires. The RC will coordinate with RadCon to make everything run smoothly.
- The operators have been somewhat careful with our beam orbit locks. Please make sure that the orbit locks are enabled and the beam does not drift from its nominal position.