Difference between revisions of "How-to"
From HallCWiki
Jump to navigationJump to search| Line 8: | Line 8: | ||
* [[Beam Checkout Procedures]] | * [[Beam Checkout Procedures]] | ||
| + | |||
| + | * [[Hall-C HMS DAQ Failure Modes | How to recover HMS DAQ failure modes during Spring 2018 commissioning run]] | ||
* [[Hall-C ROC3 Current Trip | How to recover from ROC3 current trip]] | * [[Hall-C ROC3 Current Trip | How to recover from ROC3 current trip]] | ||
Revision as of 19:43, 27 February 2018
NOTE: If you can't solve the problem in 1 hour you MUST then contact the Run Coordinator! (See also Experts on call)
How-to's
- The Hall C Operations Manual is a thorough and up-to-date set of instructions.
- Collimator control for HMS/SHMS. Also includes description of the collimators.
- EPICS screens can be found at jmenu -> <search for> "HMS coll" and you'll see both entries
- The usual collimator settings are HMS : "Pion Collimator" and SHMS : "Collimator".
- Hall C Scalers & xscalers instructions for HMS and SHMS.
- SHMS drift chamber instructions
- Hall C DAQ Instructions
- High Voltage Controls
- EPICS/Accelerator Screens
- Also includes Stripcharts, Gas System info, Collimator controls, Chamber Thresholds, Harps, etc...
- Hall C BPMs
- Run go_bpms from the cdaq account
- How to see results of Hall C harp scans
- How to bring up the Hall C YAG Viewer camera
- How to bring up the Alarm Handler
- How to bring up the Hall C cameras
- How to restore the Hall C EDTM Pulser
- How to check the HMS/SHMS shutters
- How to perform pedestal runs and determine FADC thresholds
- How to perform raster runs (this is the equivalent of spot++)
Spectrometer Magnets
- Magnet screen is brought up on any hcdesk machine by the command go_magnets
- How to operate and monitor the Spectrometer Magnets
- Spectrometer Magnets Cryogenics
- Resetting Magnet Interlocks
How to Rotate the HMS and SHMS
SHMS Detectors
HMS Detectors
Hall C target
Hall C target configuration for Spring 17 running
