Difference between revisions of "How-to"
From HallCWiki
(→How-to's) |
(→HMS Detectors) |
||
| Line 61: | Line 61: | ||
== HMS Detectors == | == HMS Detectors == | ||
*[[Pre-12 GeV HMS Drift Chambers | Pre-12 GeV Drift Chambers]] | *[[Pre-12 GeV HMS Drift Chambers | Pre-12 GeV Drift Chambers]] | ||
| − | *[[Post-12 GeV | + | *[[Post-12 GeV HMS Drift Chambers | Post-12 GeV Drift Chambers]] |
*[[HMS Hodoscopes | Hodoscopes]] | *[[HMS Hodoscopes | Hodoscopes]] | ||
*[[HMS Calorimetry | Calorimetry]] | *[[HMS Calorimetry | Calorimetry]] | ||
Revision as of 15:07, 24 August 2018
NOTE: If you can't solve the problem in 1 hour you MUST then contact the Run Coordinator! (See also Experts on call)
Contents
How-to's
- The Hall C Operations Manual is a thorough and up-to-date set of instructions.
- Make HCLog entries using the logbook page, or by running 'hclog' in a terminal.
- Please be concise, but clear. Assume you will need to search for, and understand, an entry 12 months from now (or longer).
- Electronic Shift Checklist should be completed once per shift.
- This 'How to' page can help you find most items (see below). You may also find the instructions here helpful.
- DAQ Related Help
- Collimator control for HMS/SHMS. Also includes description of the collimators.
- EPICS screens can be found at jmenu -> <search for> "HMS coll" and you'll see both entries
- The usual collimator settings are HMS : "Large Collimator" and SHMS : "Collimator".
- Hall C Scalers & xscalers instructions for HMS and SHMS.
- SHMS drift chamber instructions
- High Voltage Controls
- Run 'go_hv' and follow instructions
- EPICS/Accelerator Screens
- Also includes Stripcharts, Gas System info, Collimator controls, Chamber Thresholds, Harps, etc...
- Hall C BPMs: Run go_bpms from the cdaq account
- How to see results of Hall C harp scans
- How to bring up the Hall C YAG Viewer camera
- How to bring up the Alarm Handler
- How to bring up the Hall C cameras
- How to restore the Hall C EDTM Pulser
- How to check the HMS/SHMS shutters
- How to perform pedestal runs and determine FADC thresholds
- How to perform raster runs (this is the equivalent of spot++)
- How to check the HMS discriminator threshold read back
Spectrometer Magnets
- Magnet screen is brought up on any hcdesk machine by the command go_magnets
- Note: only ONE copy of the magnet control GUI screen can be running. Creating a new one will cause the old one to disappear.
- How to operate and monitor the Spectrometer Magnets
- Spectrometer Magnets Cryogenics
- Resetting Magnet Interlocks
How to Rotate the HMS and SHMS
SHMS Detectors
HMS Detectors
Hall C target
Hall C target configuration for Spring 17 running
